HP Compaq NX7300 Maintenance And Service Manual page 145

Removal and Replacement Procedures
4. Remove the following:
1 Two HM5.0×10.0 screw locks on each side of the external
2 Two Torx T8M2.5×6.0 screws (full-featured model only)
3 Three Torx T8M2.5×4.0 screws (the defeatured model
Removing the System Board Screws and Screw Locks (full-featured
model shown)
5–52
monitor connector
uses four torx screws)
Maintenance and Service Guide