HP Compaq NX6330 Maintenance And Service Manual page 144

Removal and Replacement Procedures
8. Position the base enclosure with the front toward you.
9. Flex the right-rear section of the base enclosure 1 until the
audio connectors disengage from the openings in the
base enclosure.
10. Lift the right side of the system board 2 until the board rests
at an angle.
11. Slide the system board 3 to the right and remove it from the
base enclsoure.
Removing the System Board
Reverse the above procedures to install the system board.
5–58 Maintenance and Service Guide