HP Compaq NC6140 Maintenance And Service Manual page 99

9. Remove the four Phillips PM3.0×4.0 hard drive cover
screws 1 from each side of the hard drive.
10. Remove the two Phillips PM2.0×4.0 hard drive connector
screws 2 from the front of the hard drive.
11. Lift the cover 3 straight up to remove if from the hard drive.
12. Slide the hard drive connector 4 off of the hard drive.
Removing the Hard Drive Cover
Reverse the above procedure to reassemble and install the
hard drive.
Maintenance and Service Guide
Removal and Replacement Procedures
6–9