HP Compaq NC6140 Maintenance And Service Manual page 106

Removal and Replacement Procedures
4. Make note of which antenna cable is attached to which
antenna clip on the Mini PCI communications module before
disconnecting the cables, then disconnect the auxiliary and
main antenna cables 1 from the Mini PCI communications
module.
5. Spread the two retaining tabs 2 on each side of the Mini PCI
socket to release the Mini PCI communications module. (The
edge of the module opposite the socket rises away from the
computer.)
6. Remove the Mini PCI communications module 3 by pulling
the module from the socket at a 45-degree angle.
✎
Mini PCI communications modules are designed with
notches 4 to prevent incorrect installation.
Removing a Mini PCI Communications Module
Reverse the above procedure to install a Mini PCI
communications module.
6–16 Maintenance and Service Guide