HP Compaq NC6110 Maintenance And Service Manual page 121

4. Disconnect the auxiliary and main antenna cables 1 from the
Mini PCI communications module.
✎
Make note of which antenna cable is attached to which antenna
clip on the Mini PCI communications module before
disconnecting the cables.
5. Spread the two retaining tabs 2 on each side of the Mini PCI
socket to release the Mini PCI communications module. (The
edge of the module opposite the socket rises away from the
computer.)
6. Remove the Mini PCI communications module 3 by pulling
the card away from the socket at a 45-degree angle.
✎
Mini PCI communications modules are designed with notches 4
to prevent incorrect installation.
Removing a Mini PCI Communications Module
Reverse the above procedure to install a Mini PCI
communications module.
Maintenance and Service Guide
Removal and Replacement Procedures
6–15