Rear Cover - HP Compaq 6530b Maintenance And Service Manual

Remove the USB/digital media board cable:
1. Disconnect the USB/digital media board cable (1) from the system board.
2. Remove the three Phillips PM2.5×5.0 screws (2) that secure the USB/digital media board to the
base enclosure.
3. Remove the USB/digital media board (3).
Reverse this procedure to install the USB/digital media board.

Rear cover

Description
Rear cover
Before removing the rear cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
Battery on page 46).
Hard drive on page 52)
Optical drive on page
Keyboard on page 61)
Switch cover on page
55)
65)
Component replacement procedures
Spare part number
486291-001
93