System Board - HP Compaq 2710p Maintenance And Service Manual

System board

NOTE:
All system board spare part kits include replacement thermal material.
Description
Equipped with Intel Core Duo U7600 (1.20-GHz) processor (533-MHz FSB and 2-MB L2 cache)
Equipped with Intel Core Duo U7500 (1.06-GHz) processor (533-MHz FSB and 2-MB L2 cache)
Equipped with Intel Celeron-M ULV processor
Before removing the system board, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive compartment cover (see
a.
Keyboard (see
b.
Hinge cover (see
c.
Top cover (see
d.
Display assembly (see
e.
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
SIM (see
●
Memory modules (see
●
RTC battery (see
●
Fan/heat sink assembly (see
●
Modem module (see
●
Remove the system board:
Position the computer with the left side toward you.
1.
Press the ExpressCard slot bezel (1) to release it from the ExpressCard slot. (The ExpressCard slot
2.
bezel is partially ejected from the ExpressCard slot.) The ExpressCard slot bezel is included in the
Plastics Kit, spare part number 454685-001.
Battery on page
Keyboard on page
Hinge cover on page
Top cover on page
Display assembly on page
SIM on page 38)
Memory module on page
RTC battery on page
Fan/heat sink assembly on page
Modem module on page
37).
Hard drive on page
48)
50)
52)
60)
47)
55)
68)
Component replacement procedures
Spare part number
455083-001
455082-001
455081-001
39)
65)
63