Display Assembly - HP Compaq 2710p Maintenance And Service Manual

Display assembly

NOTE:
All display assembly spare part kits include an ambient light sensor, fingerprint reader,
microphones, WLAN antenna cables, and WWAN antenna cables
Description
Display assembly with camera and keyboard light
Display assembly with camera
Display assembly with keyboard light
Display assembly
Before removing the display assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Disconnect the wireless antenna cables from the WLAN module (see
5.
and the WWAN module (see
Remove the following components:
6.
Hard drive compartment cover (see
a.
Keyboard (see
b.
Hinge cover (see
c.
Top cover (see
d.
Remove the display assembly:
Place the display into an upright position.
1.
Disconnect the following cables from the system board:
2.
(1) Fingerprint reader board cable
(2) Camera cable
(3) Keyboard light cable
60 Chapter 4 Removal and replacement procedures
Battery on page 37).
WWAN module on page
Hard drive on page
Keyboard on page 48)
Hinge cover on page
Top cover on page 52)
45).
39)
50)
Spare part number
454679-001
454675-001
454677-001
454676-001
WLAN module on page 41)