HP Compaq 2710p Maintenance And Service Manual page 61

Remove the following:
2.
(1) One small Mylar screw cover. All Mylar screw covers detailed in this section are included in the
Rubber Kit, spare part number 454686-001.
(2) Three Torx T8M2.0×8.0 screws.
(3) Two large Mylar screw covers. The screw covers detailed in this section are included in the Rubber
Kit, spare part number 454686-001.
(4) Two Torx T8M2.0×4.0 screws.
Turn the computer right-side up, with the front toward you.
3.
Open the computer as far as possible.
4.
Release the ZIF connector (1) to which the LED board cable is connected and disconnect the LED
5.
board cable from the system board.
Remove the two Phillips PM2.0×5.0 screws (2) that secure the top cover to the computer.
6.
Lift the front edge of the top cover (3) until it rests at an angle.
7.
Component replacement procedures 53