Hinge Cover - HP Compaq 2710p Maintenance And Service Manual

Release the ZIF connector (2) to which the keyboard cable is attached, and disconnect the keyboard
7.
cable (3) from the system board.
Remove the keyboard.
8.
Reverse this procedure to install the keyboard.

Hinge cover

NOTE:
The hinge cover is included in the Plastics Kit, spare part number 454685-001.
Before removing the hinge cover, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the hard drive compartment cover (see
5.
Remove the keyboard (see
6.
Remove the hinge cover:
Turn the computer upside down, with the rear panel toward you.
1.
50 Chapter 4 Removal and replacement procedures
Battery on page 37).
Keyboard on page 48).
Hard drive on page 39).