Step 4: Turn On The Computer; Step 5: Set Up The Software - HP Compaq 2710p Getting Started

Step 4: Turn on the computer

To turn on the computer:
▲ Slide the power switch to the right (1).
The power light (2) turns on.

Step 5: Set up the software

After the computer is turned on, it will go through software setup. Follow
the on-screen instructions to set up the software. Note the following points:
●
After you respond to the setup prompt, you must complete the entire
setup process without interruption. Setup time varies.
●
During software setup, the computer may pause periodically for
several minutes. These normal pauses are indicated by an hourglass
icon.
If you are prompted to select an operating system language,
CAUTION:
choose carefully. On some models, the languages that you do not choose
are deleted from the system and cannot be restored during software setup.
To register the operating system and the computer during software
NOTE:
setup, the computer must be connected by an RJ-45 (network) cable to an
existing network that has access to the Internet. If you do not register during
software setup, you can do so at any time after software setup is complete.
6 Chapter 1 First-time setup