Display Assembly - HP Compaq 2210b Maintenance And Service Manual

Display assembly

Description
12.1-inch, WXGA display assembly (includes WLAN antenna transceivers and cables)
Before removing the display assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Disconnect the wireless antenna cables from the WLAN module (see
5.
Remove the keyboard (see
6.
Remove the switch cover (see
7.
Remove the display assembly:
Close the computer and turn it upside down, with the rear panel toward you.
1.
Remove the Phillips PM2.5×7.0 screw (1) and Phillips PM2.5×5.0 screw (2) that secure the display
2.
assembly to the computer.
Turn the computer right-side up, with the front toward you.
3.
Open the computer as far as possible.
4.
Disconnect the display panel cable (1) from the system board.
5.
Battery on page 37).
Keyboard on page 47).
Switch cover on page
WLAN module on page
49).
Component replacement procedures
Spare part number
454004-001
42).
51