Table of Contents
Advertisement
Docking the Computer
WARNING:
!
hands away from the rear of the computer when docking.
CAUTION:
a computer on for the first time while it is docked.
To dock the computer in the desktop expansion base, follow
these steps:
1. Turn off the computer, if it is on. If you are not sure whether
the computer is off or in Hibernation, turn the computer on,
then shut it down.
NOTE:
shutting it down, refer to "Preparing to Dock the Computer"
in Chapter 4.
2. Turn off, then disconnect any external equipment connected to
the computer. Disconnect cables to any installed PC Cards.
Disconnect the computer power cord.
3. Slide the computer into the expansion base along the left
alignment guide
4. Push the computer toward the rear of the expansion base until
the docking connector on the computer
connector on the expansion base . This activates the
motorized docking mechanism, which pulls the computer into
a fully seated connection.
Docking the Computer in the Desktop Expansion Base
1-8 Getting Started
To avoid the risk of personal injury, keep fingers and
Set up a new computer while it is undocked. Do not turn
For information about docking the computer without
.
contacts the docking
Advertisement
Table of Contents
