Table of Contents
Advertisement
Computer Checkup (TEST) Error Codes
Computer Checkup (TEST) error codes occur if the system recognizes a problem while
running Computer Checkup. These error codes help identify possible defective
assemblies. Table 2-4 through Table 2-14 list Computer Checkup error codes, a
description of the error condition, and the recommended action for resolving the
condition. For removal and replacement procedures, refer to Chapter 5, "Computer
Removal and Replacement Procedures."
IMPORTANT: Run Computer Checkup each time you complete a recommended action
step. If the problem is resolved when POST and Computer Checkup are rerun (in other
words, with no error codes), do not perform the remaining recommended action steps.
NOTE: The error codes in the following tables are listed in an "AYE-XX" format,
where:
Error Code Description
101-xx
CPU test failed.
103-xx
DMA page registers test failed.
104-xx
Interrupt controller master test failed.
105-xx
Port 61 error.
106-xx
Keyboard controller self-test failed.
107-xx
CMOS RAM test failed.
108-xx
CMOS interrupt test failed.
109-xx
CMOS clock test failed.
110-xx
Programmable timer load data test failed.
113-xx
Protected mode test failed.
Error Code Description
200-xx
Memory machine ID test failed.
202-xx
Memory system CMOS checksum failed.
203-xx
Write/Read test failed.
204-xx
Address test failed.
211-xx
Random pattern test failed.
214-xx
Noise test failed.
215-xx
Random address test failed.
2-10 Troubleshooting
A or AA
= Number that represents the faulty assembly
YY
= Test or action that failed
XX
= Specific problem
Processor Test Error Codes
Memory Test Error Codes
Table 2-4
Recommended Action
Replace the processor board and retest.
Replace the system board and retest.
Table 2-5
Recommended Action
The following steps apply to error codes 200-xx
and 202-xx:
1. Flush the system CMOS and retest. See note.
2. Replace the system board and retest.
The following applies to error codes 203-xx
through 215-xx:
Remove and replace the SODIMM memory board
or system board (if the memory on the system
board is faulty) and retest.
Advertisement
Table of Contents
