HP 2133 Mini-Note Maintenance And Service Manual page 77

2. Remove the fan/heat sink (2).
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink
and system board components. Thermal grease is used on the video chip (1) and the surface of
the fan/heat sink (1) that contacts the video chip. Thermal tape is used on the processor (2) and
the surface of the fan/heat sink (2) that contacts the processor. Replacement thermal material is
included with all fan/heat sink and system board spare part kits.
If you have model 2140, remove the fan/heat sink:
1. Remove the three Torx8 T8M2.0×6.0 screws (1) that secure the fan/heat sink to the system board.
Component replacement procedures 69