Top Cover - HP 2133 Mini-Note Maintenance And Service Manual

Top cover

Description
Top cover for use only in model 2133
Top cover for use only in model 2140
Before removing the top cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the keyboard (see
6. Remove the hard drive or solid-state drive (see
Remove the top cover:
1. Turn the computer upside down, with the front toward you.
2. Use a thin, flat tool to release the four rubber feet (1).
CAUTION:
Exercise caution when releasing the rubber feet to prevent damaging the feet.
3. On model 2133, remove the three Torx8 T8M2.5×10.0 screws (2) and the Torx8 T8M2.0×4.0
screw (3) that secure the top cover to the base enclosure.
On model 2140, remove the three Phillips PM2.0×7.0 screws (2) and the Phillips PM3.0×3.0
screw (3) that secure the top cover to the base enclosure.
NOTE:
52 Chapter 4 Removal and replacement procedures
Battery on page
Keyboard on page
On model 2133, the rubber feet are attached to the base enclosure by tethers.
Model 2140 is illustrated. Model 2133 uses tethered feet and slightly different screw sizes.
44).
45).
Mass storage device on page
Spare part number
482265-001
511749-001
49).