Handling And Safety Instructions; Safety Symbols Information; Important Inverter Safety Instructions - SolarEdge SE8K-N4 Installation Manual

HANDLING AND SAFETY INSTRUCTIONS

During installation, testing and inspection, adherence to all the handling and safety instructions is
mandatory. Failure to do so may result in injury or loss of life and damage to the equipment.

Safety Symbols Information

The following safety symbols are used in this document. Familiarize yourself with the symbols and their
meaning before installing or operating the system.
WARNING!
Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could
result in injury or loss of life. Do not proceed beyond a warning note until the indicated conditions
are fully understood and met.
CAUTION!
Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could
result in damage or destruction of the product. Do not proceed beyond a caution sign until the
indicated conditions are fully understood and met.
NOTE
Denotes additional information about the current subject.
IMPORTANT SAFETY FEATURE
Denotes information about safety issues.
Disposal requirements under the Waste Electrical and Electronic Equipment (WEEE) regulations:
NOTE
Discard this product according to local regulations or send it back to SolarEdge.
IMPORTANT INVERTER SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING!
The inverter cover must be opened only after shutting off the inverter ON/OFF switch located at the
bottom of the Primary Unit, above the Connection Unit. This disables the DC voltage inside the inverter
and opens the AC relays. Wait five minutes before opening the cover. Otherwise, there is a risk of
electric shock from energy stored in the capacitors.
WARNING
Before operating the inverter, ensure that the inverter is grounded properly.
WARNING!
Opening the inverter and repairing or testing under power must be performed only by qualified service
personnel familiar with this inverter.
Three Phase Inverter with synergy technology Guide MAN-01-00402-1.1
HANDLING AND SAFETY INSTRUCTIONS
7