Table of Contents
Advertisement
Install the WiFi Extender
Place the extender, apply power, and connect the extender to your existing WiFi network.
Place the Extender and Apply Power
To place the extender and apply power:
1.
Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup process.
2.
Plug the extender into an electrical outlet.
3.
Wait for the Power LED to light amber and then turn green.
If the Power LED does not light, press the Power On/Off button on the extender.
Connect to an Existing WiFi Network
To extend the range of your WiFi network, you must connect the extender to your existing WiFi network.
Note
If your router's WiFi security is set to WPA enterprise or WPA2 enterprise, your
extender can't connect to your router. You must change your router's WiFi security
setting.
You can connect the extender in one of two ways:
•
Connect with WPS. For more information, see
Note
WPS does not support WEP network security or a hidden SSID network. If your router
WiFi network uses WEP security or its SSID is hidden, follow the instructions in
Connect With the NETGEAR Installation Assistant
•
Connect with web browser setup. For more information, see
Assistant
on page 15.
Connect With WPS
Wi-Fi Protected Setup (WPS) lets you join a secure WiFi network without typing the network name and
password. For help with the WPS button on your WPS-enabled device, check the instructions or online help
that came with that device. Some older equipment cannot use WPS.
Note
WPS does not support WEP network security or a hidden SSID network. If your
existing WiFi network uses WEP security or its SSID is hidden, follow the instructions
in
Connect With the NETGEAR Installation Assistant
Nighthawk X6S AC3000 Tri-Band WiFi Range Extender
Connect With WPS
on page 15.
Connect With the NETGEAR Installation
on page 15.
Get Started
13
on page 13.
Advertisement
Table of Contents
