Assembly Preparation; Assembly Instructions; Assembling The Cart; Mounting The Cart Panels - Louisiana Grills 60815 Assembly And Operation Manual

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack
after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before
assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to
assemble. Shipping damage is not covered under warranty. Contact your dealer or Louisiana Grills Customer Service for parts:
Monday through Sunday, 4am - 8pm PST (EN/FR/ES).
service@louisiana-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver, wrench and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed.

1. ASSEMBLING THE CART

Parts Required:
4 x Support Leg (#17)
Bottom Shelf (#26)
1 x
Screw (#A)
16 x
Installation:
• Place a piece of cardboard on the floor to prevent scratching the
unit and parts during assembly. Prepare the four support legs for
installation, arranging the labelled legs as shown in illustration 1A.
• Attach one support leg by carefully sliding it into a corner of the
bottom shelf, then secure using four screws. Ensure the two holes
on the bottom shelf are front facing. Repeat installation for the
other three support legs to the remaining three corners of the bottom
shelf. Note illustration 1B.

2. MOUNTING THE CART PANELS

Parts Required:
Cart Back Panel (#24)
1 x
2 x Cart Side Panel (#25)
12 x Screw (#B)
Installation:
• Attach the cart back panel to the rear support legs of the cart, and
secure the inside edges using four screws: one screw on each corner of
the cart back panel. Repeat the same installation to mount the two
cart side panels to the other support legs.
NOTE: Once installed, the exterior of the cart panels are flush with
the support legs and bottom shelf.

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

1A
17
17
17
1B
2
25
26
17
24
25
7