Table of Contents
Advertisement
e.
Remove the touch control board from the display assembly.
6.
To remove the display hinge covers:
a.
Remove the Phillips PM2.0×5.0 screw (1) that secures each hinge cover to the display enclosure.
b.
Slide the right hinge cover toward the right and the left hinge cover toward the left (2) to remove
them from the display.
c.
For installation, note the routing of the display cable through the left hinge cover (3) and display
cable through the right hinge cover (4).
7.
To remove the display hinges:
a.
Remove the Phillips PM2.0×3.0 screw (1) from the top of each hinge and three Phillips PM2.5×4.0
screws (2) from the bottom of each hinge.
72
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Advertisement
Table of Contents
