Table of Contents
Advertisement
●
WLAN module (see
Memory modules (see
●
●
Solid-state drive (if installed) (see
Heat sink assembly (see
●
To remove the system board:
1.
Position the computer upright, and then disconnect the following cables from the system board:
(1): Power connector cable
(2): Display cable
(3): Power button board
(4): Speaker cable
(5): TouchPad cable
(6): Touchpad board cable
(7): USB board cable
(8): Optical drive connector cable
(9): Keyboard cable
2.
Remove the seven Phillips PM2.0×3.0 screws (1) that secure the system board to the computer.
3.
Remove the Phillips broadhead PM2.0×2.0 screw (2) that secures the system board to the computer.
WLAN module on page
45)
Memory module on page
Solid-state drive on page
Heat sink assembly on page
48)
50)
58)
Component replacement procedures
63
Advertisement
Table of Contents
