Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual page 60

1. GENERAL
The stabilizers, elevators, and rudder are constructed of tubular steel with steel channel ribs.
Stainless steel tie rods and fittings brace the horizontal stabilizers to the vertical stabilizer and
fuselage.
The aircraft is trimmed in flight by changing the stabilizer's angle of incidence. The pitch trim is
controlled by an electric servo, which moves the leading edge of the horizontal stabilizer up and
down. The servo is actuated with a rocker switch located on the front control stick. Some
aircraft are equipped with an aft control stick rocker switch.
2. MAINTENANCE
Refer to Section 6.3.5 for maintenance and servicing of the empennage. No major repair or
alterations, as outlined in ASTM F2483, FAR 43, or in this manual are authorized at this time.
To obtain engineering approvals for any major repairs or alterations, please contact Cub
Crafters at:
Cub Crafters, Inc.
th
1918 South 16 Avenue
Yakima, WA. 98903
Tel: 509-248-9491
support@cubcrafters.com
5.4.4
Page: 2
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Manual number SSC10000AMM
Date: 10/28/2010