Troubleshooting; Removal; Inspection; Installation - Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual

(2) TROUBLESHOOTING

PROBLEM
Starter turns engine slowly
when cold
Starter turns engine slowly
when hot
When starter engages, it
makes a loud grinding noise
When the starter is engaged,
there is a click and the
engine does not turn
Starter drive gear stays
engaged for some length of
time after the ignition switch
is released

(3) REMOVAL

(a) Disconnect the power cable.
(b) Unbolt the starter attachment bolts and nuts.
(c) Retain all existing attach hardware except lock washers which will be replaced.

(4) INSPECTION

(a) Visually inspect the teeth of the starter gear and starter's housing for damage.
(b) Visually inspect electrical connections on the starter.

(5) INSTALLATION

(a) Secure the starter using the original hardware minus new lock washers.
(b) Torque the bolts and/or nuts.
(c) Attach the power cable using the nut and new lock washer. Torque the nut.
Manual number SSC10000AMM
Date: 04/18/2013
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
PROBABLE CAUSE
Weak battery
Bad connection, cable, or
solenoid
Starter damaged by engine
kicking back
Voltage not getting to starter
Starter solenoid defective
Stuck starter solenoid
CAUTION
Do not over torque the nut on the stud.
REMEDY
- Charge battery
- Test
- Replace, if necessary
- Clean connections and/or
- replace faulty component
- Correct the ignition problem
- Repair or replace starter
- Replace starter solenoid
- Replace faulty starter
solenoid
- Replace or repair starter
6.3.17
Page: 5