Servicing - Oil System; Changing Engine Oil - Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual

2 SERVICING – OIL SYSTEM
The oil system is an integral part of the engine, except for the cooler that is mounted on the left
side of the firewall.
2.1.

CHANGING ENGINE OIL

(a) Warm engine
(b) Remove the upper and lower engine cowlings. (Refer to Chapter 6.3.15)
(c) Place a suitable drain pan under the oil drain.
(d) Open the oil drain. Allow the oil to completely drain out.
(e) Clean oil screen and replace oil filter (if installed)
(f) Close the oil drain making sure it is sealed.
(g) Fill the engine with an approved oil.
(h) Verify oil quantity with the dipstick.
(i) Secure dipstick.
(j) Install engine cowling. (Refer to Chapter 6.3.15)
Start the engine in accordance with Pilot's Operating Handbook procedures
(k)
and monitor the engine oil pressure gauge for proper oil pressure. Allow
the engine to idle for a few minutes and shutdown the engine in accordance
with POH procedures.
(l) Visually check inside of cowling for any obvious leaks and correct them as
necessary.
If the oil pressure does not rise in 30 seconds, stop the engine and determine the
Manual number SSC10000AMM
Date: 04/18/2013
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
CAUTION
trouble.
6.3.10
Page: 5