Disassembly; Inspection - Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual

Refer to Figure 6.3.8.2

(1) DISASSEMBLY

(a) Deflate the tube (12).
(b) Break the tire bead loose from the wheel.
(c) Remove the wheel half nuts (5) and bolts (6).
(d) Pull the wheel hubs (8) apart being careful with the valve stem.
(e) Remove the spacer (1), grease retainer (2), inner spacer (3) and bearing (4) from
each hub.

INSPECTION

(2)
(a) Wipe the tire and the tube with a dry cloth. If the tire or the tube is spotted with
grease, oil or other deposits, wash in a solution of soap and water. Rinse with
clean water and dry with a clean cloth.
(b) Visually inspect the tire inside and out for cuts, uneven or excessive wear, and
penetration by foreign objects. Replace if the tire is in poor condition.
(c) Visually inspect the inner tube for wear, cuts or cracks taking a close look at the
valve stem base. Replace if the tube is in poor condition.
(d) The tire should be removed when the tread is worn to the base of a groove. Tires
that are worn through the top fabric layer can only remain in service long enough
to return to a maintenance base to be replaced.
(e) Clean all metal parts (including the bearings) in a cleaning solution. Dry all parts
with compressed air.
(f) Inspect the bearing and races for wear or damage. Replace if necessary.
Manual number SSC10000AMM
Date: 10/28/2010
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
6.3.8
Page: 7