Cleaning; Inspection; Minor Repairs; Replacement Of Parts - Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual

(a) Remove the tire assembly from the fork by removing the cotter pin (1), castle nut
(23), and washer (3) then sliding the axle (21) out.
(b) At the bottom of the fork (4) remove the cotter pin (1), short castle nut (2), and
washer (3). Carefully pull the fork (11) off of the bracket (1).
(c) Separate the spacer (22), grease retainer (14), and the bearing (15) from the fork
(4).
(d) Disengage the lower dust cap (5), thrust washer (7), arm assembly (8), thrust
washer (7), pawl (6), upper dust cap (9), springs (10), thrust plate (11), and fiber
thrust plate (12) from the fork (4) and bracket (13).

(3) CLEANING

Clean all metal parts (including the bearings) in a cleaning solution. Dry all parts with
compressed air.

(4) INSPECTION

See Figure 6.3.7.4 and Figure 6.3.7.5
(a) Check the leaf springs for damage or twisting. (Figure 6.3.7.4)
(b) Replace if condition dictates.
(c) Inspect the arm assembly (8, Figure 6.3.7.5), flat spring (17, Figure 6.3.7.5), fork
(4, Figure 6.3.7.5), and bracket (13, Figure 6.3.7.5) for excessive wear, cracks or
other damage. Replace damaged parts.
(d) Examine the thrust washers (7, Figure 6.3.7.5) for wear, scoring, or other
damage. Replace if necessary.
(e) Inspect the bearing (15, Figure 6.3.7.5) and races for wear or damage. Replace
if necessary.

(5) MINOR REPAIRS

See Figure 6.3.7.5
The components that make up the tail wheel assembly may not be repaired except
that minor realignments are permitted, such as minor dents and bends.

(6) REPLACEMENT OF PARTS

Replace all cotter pins that have been removed with new cotter pins.
Manual number SSC10000AMM
Date: 04/29/2009
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
6.3.7
Page: 17