Inspection; Minor Repairs; Replacement Of Parts; Reassembly - Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual

(4) INSPECTION

See Figure 6.3.7.3
(a) Check the leaf springs for damage or twisting.
(b) Replace if condition dictates.
(c) Inspect the arm assembly, fork, and bracket for excessive wear, cracks or other
damage. Replace damaged parts.
(d) Examine the washers for wear, scoring, or other damage. Replace if necessary.
(e) Inspect the bearing and races for wear or damage. Replace if necessary.

(5) MINOR REPAIRS

See Figure 6.3.7.3
The components that make up the tail wheel assembly may not be repaired except
that minor realignments are permitted, such as minor dents and bends.

(6) REPLACEMENT OF PARTS

Replace all nuts that have been removed with new nuts.

(7) REASSEMBLY

See Figure 6.3.7.3
(a) Hand apply grease to all internal parts and pack the bearing (15) with grease
(MIL-G-81322E).
(b) Place the arm assembly and washers on the fork and secure with the nut.
(c) These last steps may be accomplished once the tail wheel assembly is installed
back on the fuselage.
(d) Check to verify proper tail wheel pivoting and tension.
(e) Install the tire assembly on the fork by sliding the axle through the fork and tire
assembly.
(f) Secure with the nut.
6.3.7
Page: 12
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Manual number SSC10000AMM
Date: 04/29/2009