3
TAIL LANDING GEAR
3.1
STANDARD STEERABLE TAIL WHEEL
(1) REMOVAL
i - Nut
iv - Clamp
vii - Small Bolt (2)
x – Bushing
Figure 6.3.7.2: Standard Tail Wheel and Leaf Spring Installation
(a) Lift the tail section of the airplane and rest the fuselage on a bench so the tail
landing gear clears the ground.
(b) Disconnect the chain links from the tail wheel arms.
(c) Remove the front tail spring attach nut (i) and washer (ii).
(d) Disconnect the tail spring clamp (iv) by removing the nuts (v), washers (vi) and
bolts (vii).
(e) To separate the springs from the tail wheel, remove the large area nuts (viii),
washers (ii), and bolts (x).
6.3.7
Page: 10
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
ii - Washer (4)
v - Small Nut (2)
viii - Large Area Nut
iii - Long Bolt
vi - Small Washer (2)
ix - Bolt
Manual number SSC10000AMM
Date: 04/29/2009