Installation - Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual

(3) INSTALLATION

(a)
(b)
(c)
(d)
Manual number SSC10000AMM
Date: 04/29/2009
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Insert the shock assembly in the strut. Insert a bolt with a washer through
the shock and strut and place a washer and nut on the end of the bolt.
Torque the nut to 160-200 in·lbs.
Place the bungee cover end over the top shaft of the shock assembly.
Align with the top shock hole and the holes in the cabane vee and insert
bolt.
Place the washer and the nut on the end of the bolt. Torque to 130 in·lbs.
If necessary, tightened past this torque value to align the nut with the
nearest hole in the bolt. Safety the nut with a new cotter pin.
Verify that all hardware is installed properly then lower the aircraft back to
the ground.
6.3.7
Page: 7