Rigging - Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual

(3) RIGGING

Figure 6.3.6.4: Alignment of Aileron Trailing Edge with Flap Trailing Edge
(a) The neutral position of the ailerons is found by matching as closely as possible,
the trailing edge of the ailerons with the trailing edge of the wing tip.
Figure 6.3.6.5: Alignment of Aileron Trailing Edge with Wing Tip
(b) The ailerons must be rigged so that the top aft edge of the outboard end rib of
either aileron does not extend more than 1/4-inch above or 1/4-inch below the
top aft edge of the end wing rib with the control stick deflected right 1° ± 1° of
vertical. (See Figure 6.3.6.5)
(c) To raise the trailing edge of an aileron, take up the turnbuckle at the upper
aileron horn and simultaneously let out the turnbuckle at the lower aileron horn.
(d) The aileron trailing edge may be lowered by reversing the procedure. Ensure
that the cable tension is 40 ± 5 lbs. (Refer to Section 5.2).
Leave no more than 3 threads visible at each end of the turnbuckle barrels.
6.3.6
Page: 6
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
CAUTION
Manual number SSC10000AMM
Date: 04/24/2009