Right Horizontal Stabilizer Installation - Cub Crafters CARBON CUB SS CC11-160 Maintenance Manual

(a) Unbolt the upper and lower tail brace wire assemblies.
(b) Unbolt the left stabilizer from the tubes and carefully pull it off.
(c) Carefully slide the right stabilizer, together with the tubes, out of the mounting
points in the fuselage.

(3) RIGHT HORIZONTAL STABILIZER INSTALLATION

1 - Long Bolt
2 - Bolt
3 - Thin Washer
Refer to Figure 6.3.5.6
(a) Identify the right stabilizer (note that the fabric seam should be on the bottom of
the surface). Lay the stabilizer on a suitable work surface and apply a thin coat of
grease (MIL-G-81322E) to the inside ends of the front and rear tubes.
Manual number SSC10000AMM
Date: 04/18/2013
CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
4 - Thick Washer
5 - Nut
6 - Front Stabilizer Tube
Figure 6.3.5.6: Horizontal Stabilizer Installation
7 - Rear Stabilizer Tube
6.3.5
Page: 7