Table of Contents
Advertisement
12.
To remove the display/webcam cable, lift the tape from atop the connector on the webcam module (1),
and then disconnect the cable from the webcam module (2). Lift the cable from the display enclosure to
disengage the adhesive that secures it (3).
13.
To remove the wireless antennas and cables, release the wireless antenna cables from the clips (1) built
into the side of the display enclosure, and then peel the antennas of the display enclosure (2) to remove
the antennas and cables.
NOTE:
Number of antennas and transceivers may vary.
14.
If replacing the display enclosure, be sure that the subcomponents are transferred to the new enclosure.
Reverse this procedure to reassemble and install the display assembly.
Display assembly
57
Advertisement
Table of Contents
