Solid-State Drive - HP 240 14 inch G9 Maintenance And Service Manual

2. Remove the memory module (2) by pulling it away from the slot at an angle.
Reverse this procedure to install a memory module.

Solid-state drive

To remove the solid-state drive, use this procedure and illustration.
Table 5-7 Solid-state drive descriptions and part numbers
Description
256 GB, PCIe
128 GB, PCIe, TLC
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
Computer feet on page
Bottom cover on page
Battery on page
Solid-state drives are designed with notches to prevent incorrect insertion.
Preparation for disassembly on page
32).
33).
35).
Spare part number
L85354-005
M06792-005
32).