HP 240 14 inch G9 Maintenance And Service Manual page 46

3. Remove the bottom cover (see
4. Remove the battery (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
antenna cable is connected to the WLAN module Aux terminal.
2. Remove the Phillips M2.0 × 3.0 screw (2) that secures the WLAN module to the system board. (The WLAN
module tilts up.)
3. Remove the WLAN module by pulling the module away from the slot at an angle (3).
NOTE: If the WLAN antennas are not connected to the terminals on the WLAN module, the protective
sleeves must be installed on the antenna connectors, as shown in the following illustration.
38 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page
The #1 WLAN antenna cable is connected to the WLAN module Main terminal. The #2 WLAN
33).
35).