Loop Lock Operation; Safety Precautions - Drive RTL800KD-BK Manual

Loop Locks
Backrest
Height
Adjustment Knobs
Folding Hinge
for Portability
Wheel Tightening
Knob
WEIGHT CAPACITY 350 LBS (158 KG)

safety precautions

1. Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in the
down position.
2. Be sure that both knobs are fully tightened and are at
equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from rolling. If the wheels
roll while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should roll freely.
4. Always lock loop locks before sitting and do not use
seat when unit is on an incline or uneven ground.
5. Replace tires when significantly worn or damaged.
Important Safety Notice
Do not have anyone push you while you are seated on the
Rollator. This is a walking aid only and is not to be used as
a transportation device.
Orthodic
Hand Grips
Comfortable
Padded Seat
Hanging Bag
for Functionality
& Storage

loop lock operation

Always engage and disengage wheel locks on both sides
simultaneously.
1. To Slow Down or Come to a
Temporary Stop—Pull up slowly on
the loop locks with four fingers until
unit slows down or comes to a
temporary stop.
2. To Temporarily Lock Wheels in
Position—Gently press down on both
loop locks with palms until you hear
a "click" that will tell you wheels are
locked.
3. To Release Wheel Locks—
Pull up on both loop locks with
palms of hand to original position.
instructions to adjust the
hand brake system
Important Safety Notice
The hand brake system fitted on this rallator complies
with the manufacturer's quality standards. The hand
brake system has been preset (adjusted) to the best
performance settings. To better suit you personally, please
follow the instructions set out below. You may need to
adjust the hand brake systems from time to time as they
will wear out with normal use.
Hold firmly in place
do not turn.
To tighten the hand
brake adjustment.
"turn the nut clockwise"
To loosen the hand
brake adjustment.
"turn the nut counter
clockwise"