Section 1 - General Information And Safety; Introduction; Warranty - York YCAE065 Manual

SECTION 1 – GENERAL INFORMATION AND SAFETY

INTRODUCTION

YORK YCAE065/100/130X (18-36 ton, 65-130 kW) chillers and heat pumps are manufactured to the
highest design and construction standards to ensure high performance, reliability and adaptability to
all types of air conditioning installations.
The unit combines a multiple step control design with tandem technology allowing the unit's
compressors to operate more efficiently across all capacity-load and ambient-temperature conditions.
The unit is intended for cooling and heating water and is not suitable for purposes other than those
specified in this manual.
This manual contains all the information required for correct installation and commissioning of the unit,
together with operating and maintenance instructions. The manual should be read thoroughly before
attempting to operate or service the unit.
All procedures detailed in the manual, including installation, commissioning and maintenance tasks
must only be performed by suitably trained and qualified personnel.
The manufacturer will not be liable for any injury or damage caused by incorrect installation,
commissioning, operation or maintenance resulting from a failure to follow the procedures and
instructions detailed in the manual.

WARRANTY

Johnson Controls warrants all equipment and materials against defects in workmanship and materials
for a period of one year from date of initial start-up or eighteen (18) months from date of shipment,
whichever occurs first, unless labor or extended warranty has been purchased as part of the contract.
The warranty is limited to parts only replacement and shipping of any faulty part, or sub-assembly,
which has failed due to poor quality or manufacturing errors. All claims must be supported by evidence
that the failure has occurred within the warranty period, and that the unit has been operated within
the designed parameters specified.
All warranty claims must specify the unit model, serial number, order number and run hours/starts.
Model and serial number information is printed on the unit identification plate.
The unit warranty will be void if any modification to the unit is carried out without prior written approval
from Johnson Controls.
For warranty purposes, the following conditions must be satisfied:
•
The initial start of the unit must be carried out by trained personnel from an Authorized Johnson
Controls Service Center.
•
Only genuine YORK approved spare parts, oils, coolants, and refrigerants must be used.
•
All the scheduled maintenance operations detailed in this manual must be performed at the
specified times by suitably trained and qualified personnel.
Cooke Industries - Phone: +64 9 579 2185 Email: sales@cookeindustries.co.nz Web: www.cookeindustries.co.nz