Immergas BASIC MAGIS PRO Instructions And Warnings page 80

Victrix Hybrid Plus Indoor Unit installation operations in
Solar Container.
To install this version it is necessary to have the Victrix Hybrid
Plus accessory kit for pairing.
Then proceed as follows::
• Discard the indicated components (Ref. b Fig. 23) from the
"Basic Magis Pro accessory unit" and use those in the optional
additional Kit and supplied in the connection unit of the Victrix
Hybrid Indoor Unit (Ref. V Fig. 23).
Then proceed as follows::
• Tighten the bracket (E) to the special upper cross member with
screws (f).
• Hang the indoor unit (P) on the bracket (E) installed previously
(Fig. 22).
80
f
P
• Remove the by-pass pipe between the storage tank unit flow and
return (MU-RU) from the indoor unit.
Attention: remove the grill and all the connection pipes with the
relative fittings and taps from the Victrix Hybrid Plus indoor unit.
Attention: in this installation it is essential to fit the cap on the
storage tank unit return fitting of the indoor unit.
N.B.: To choose the Immergas flue to be combined with the Ma-
gis Combo V2 Indoor Unit, refer to the instructions given in the
specific use and maintenance manual of it.
E
1
1
2
f
2
22
P