Advertisement
Available languages
Available languages
4. Release the plunger knob on the barrel.
5. Raise or lower the bed rail until the plunger pin clicks securely into the adjustment
hole or until the bed rail stop rests against the barrel.
6. Insert the inner telescoping tube of the bed rail into the barrel of the foot end
crossbrace.
7. Repeat STEPS 3-5 for the inner telescoping tube of the bed rail, adjusting the bed rail
to the position reached in STEP 5.
8. Repeat STEPS 1-7 to install the other bed rail onto the opposite side of the bed.
Operating Instructions
NOTE: READ AND UNDERSTAND WARNINGS before proceeding with Operating
Instructions.
Lowering/Raising the Bed Rails
1. Hold bed rail while pulling the plunger knob.
2. Lower/raise bed rail.
3. Release plunger knob and lower/raise the bed rail until the plunger pin clicks into
position unless the bed rail is at the lowest position.
NOTE: The lowest position for the bed rail is when the bed rail rests against the bed rail stop.
Spring loaded pins DO NOT have an adjustment hole to engage into when the bed rail is in the
lowest position.
4. Repeat STEPS 1-3 for opposite end of bed rail.
NOTE: Ensure head end and foot end of bed rails are adjusted to the same height.
Patient entrapment with bed side rails may cause injury or death. Mattress must fit bed frame
and side rails snugly to prevent patient entrapment. Follow the manufacturer's instructions.
Monitor patient frequently. Read and understand the Owner's/Operator's Manual prior to
The outer telescoping tube of the bed rail MUST be
positioned at the head end of the bed to prevent a pinch
point when raising/lowering bed.
Barrel
Slot Toward
Center of Bed
WARNING
WARNING
Plunger Knob
FIGURE 2 Installing the Bed Rails
Outer Telescoping Tube
P/N 1130183 Rev A - 11/04
Inner
Telescoping
Tube
Foot End
4
Head End
Crossbrace
Advertisement
