Craftsman CMXEOCG232 Owner's Manual page 6

PLANNING (CONTINUED)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require reinforcement.
If your door is lightweight, refer to the information relating to
sectional doors in Installation Step 8.
• Depending on your door's construction, you may need
additional mounting hardware for the door bracket
(Installation Step 8).
ONE-PIECE DOOR WITHOUT TRACK
Header W all
Gap between floor
and bottom of door must
Safety Reversing Sensor
not exceed 1/4" (6 mm).
ONE-PIECE DOOR WITH TRACK
Safety Reversing Sensor
Rail
Slack in chain tension
is normal when garage
door is closed.
Access
Door
Safety Reversing
Sensor
Access
Door
Safety Reversing Sensor
Gap between floor and bottom of door must
not exceed 1/4" (6 mm).
Without a properly installed safety reversing sensor, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing garage door.
• The gap between the bottom of the garage door and the floor
MUST NOT exceed 1/4" (6 mm). Otherwise, the safety
reversal system may NOT work properly.
• The floor or the garage door MUST be repaired to eliminate
the gap.
Motor Unit
Wall-mounted
Door Control
Header
Bracket
Door Bracket
Header
Wall
CLOSED POSITION
Rail Tab
Heade r
Wall
Header
Rail
Bracket
Straight Door
Door
Arm
Bracket
Garage
Door
6
CLOSED POSITION
Rail Tab
Cable
Rail
Straight
Curved
Door
Door
Arm
Arm
Garage Door
Chain
Cable
Emergency
Release
Rope & Handle
Curved
Door Arm