Washing Your Fluffy™ Cleaner Head; Brush Bar - Dyson v8 User Manual

Washing your Fluffy™
cleaner head brush bar
Your Fluffy™ cleaner head has a washable brush bar. To maintain optimum
performance, check and wash your brush bar regularly.
Make sure your machine is disconnected from the charger and take care not
to touch the trigger.
Remove your brush bar
Don't put any part of your machine in a dishwasher or use detergents,
polishes or air fresheners.
Press the cleaner head release button on the end of the wand. Place the
cleaner head upside down.
Push the end cap up fully and pull the brush bar out of the cleaner head.
Remove the end cap from the brush bar. Don't wash the end cap.
Wash and dry your brush bar
Hold your brush bar under running water and gently rub to remove any lint
or dirt.
Remove as much excess water as possible, run your hand down the length
of the brush bar to squeeze out the water.
Stand your brush bar upright, with the closed end at the top. Leave to dry
completely for at least 24 hours.
Replace your brush bar
Before replacing, check that your brush bar is completely dry.
Reattach the end cap to your brush bar.
Slide your brush bar into the cleaner head. Push the end cap back down to
the closed position.
The end cap
is located at
the side of the
cleaner head.
Push this
upwards to
unlock the brush
bar. Don't wash
the end cap.
The two ends of the main
brush bar showing the
closed in end being the
correct one to have facing
upwards when leaving the
brush bar to dry.
The end cap
should be
attached to the
cleaner head
at an angle less
than 90°, any
angle greater
than this will not
allow the end
cap to close.
The brush bar reinserted
into the cleaner head
and the end cap rotated
to the locked position.
The brush bar
has an open
end and
a closed end.
Stand upright,
with the closed
end facing
upwards, to dry.