Oiling System
Oil Requirements
Oil Requirements
NOTICE
If the outboard will be operated in tempera-
tures below freezing (32°F, 0°C), use Evinrude
XD100.
Recommended Lubricants
NOTICE
Failure to follow these recommendations
could void the outboard warranty if a lubrica-
tion-related failure occurs.
Evinrude XD100, or XD50 outboard oils are rec-
ommended for use in Evinrude E-TEC G2 out-
boards. If these oils are not available, use a TC-
W3 certified SYNTHETIC oil.
Evinrude XD100 outboard oil is highly recom-
mended for all conditions and applications.
Checking Oil Level
Make sure the outboard is in the vertical position
when checking oil level. Use the digital gauge or
display to check the oil level.
Optional Remote Oil Tank Kits
The following optional accessory kits are available
for use with Evinrude E-TEC G2 models:
•
Remote Oil Tank Kit, 1.8 gallons (6.8 liters),
P/N 5008571
•
Remote Oil Tank Kit, 3.0 gallons (11.3 liters),
P/N 5008572
•
Oil Tank Pick-up Kit, P/N 767686, for the 10 gal-
lon (37.8 liters) capacity oil tank.
192
Components
The oiling system consists of the following compo-
nents:
•
Oil tank
•
Crankcase oil pump and manifold assembly
•
Electrical circuit
•
Oil level sender
•
LOW OIL switch
•
LOW OIL and NO OIL warning systems
•
Cylinder oil pump and manifold assembly
•
Oil recirculation system
Oil Tank Assembly
The oil tank is located on the starboard side of the
engine and the oil level must be monitored.
Oil Tank Components:
4
Oil Tank Assembly
1. Tank, 2.0 gallon capacity
2. Oil pickup and filter assembly
3. LOW OIL switch
4. Oil level sender
5. Oil distribution hoses
5
1
2
3
009226