Electrical Harness Connections - BRP Evinrude E-TEC G2 Service Manual

Electrical and Ignition

Electrical Harness Connections

Electrical Harness Con-
nections
Inspect wiring and electrical connections. Disas-
semble and clean all corroded connections.
Replace damaged wiring, connectors, or termi-
nals. Repair any shorted electrical circuits. Refer
to wiring diagrams and reference charts for spe-
cific wiring details.
Refer to Connector Servicing on p. 139.
Engine Harness to Stator
Connector
Pin
Description of Circuit
No.
1 Stator winding (1S)
2 Stator winding (3S)
3 Stator winding (2S)
4 Stator winding (1F)
5 Stator winding (3F)
6 Stator winding (2F)
112
EMM J1-A Connector
Pin
No.
1
009175
Wire Color
Yellow
Orange
Brown
Yellow /White
Orange/White
Brown/White
Description of Circuit
1 Trim send IN
2 Manufacturing connector
3 Manufacturing connector
4 Trim sender bond
5 Manufacturing connector
6 Crankshaft position sensor (CPS)
7 Ground, CPS (digital)
8 Key Switch (Bootstrap)
9 Stop circuit
10 ETB, +5 V
11 ETB, Ground (analog)
12 Engine temperature sensor, port
13 Ground (analog)
14 Shift Actuator, Ground (analog)
15 Water pressure, +5 V
16 Ground (analog)
17 Engine temp sensor, Starboard
Ground (analog)
18 TPS A
19 Engine temp sensor, starboard
20 Air temperature sensor
21 Water in Fuel
22 Oil level sender
23 Fused +12 V
24 empty
25 empty
26 TPS B
27 Shift Actuator +5 V
28 Water pressure +5 V
29 Shift actuator positive
30 Trim sender +5 V
31 empty
32 empty
33 empty
34 empty
001875
Wire Color
White/Tan
Red
White
Dark Green
Black
Yellow
Yellow/White
Blk/Orange
Blk/Yellow
Red/White
Black/White
Pink/Black
Black/White
Black/White
Pink
Black/White
Black/White
Green/Yellow
Pink/Black
Pink/Blue
Pink/Green
Pink
Red/Purple
Green/Orange
Red/White
Red/White
Yellow/Black
Red/White