Cleaning The Glass Cooktop - GE Coil Top Owner's Manual

Cleaning the glass cooktop.

Clean your cooktop after
each spill.
Scotch-Brite Multi-Purpose
®
No Scratch blue scrub sponge
The RAZOR SCRAPER is available
through our Parts Center. See
instructions under "To Order Parts"
section on next page.
26
Normal Daily Use Cleaning
ONLY use the recommended cleaning
cream, Cerama Bryte®, on the glass
cooktop. Other creams may not be as
effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with the cooktop
cleaning cream. This helps protect
the top and makes clean-up easier.
Daily use of the cooktop cleaning
cream will help keep the cooktop
looking new.
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur if you use scrub pads other than BLUE
Scotch-Brite ® Multi-Purpose No Scratch scrub
sponges by 3M.
Allow the cooktop to cool.
Spread a few drops of Cerama Bryte®
to the entire burned residue area.
Using the scrub sponge, rub the
residue area, applying pressure as
needed.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Spread a few drops of Cerama Bryte®
to the entire burned residue area.
Hold the razor scraper at
approximately a 45° angle against
the glass surface and scrape the soil.
It will be necessary to apply pressure
to the razor scraper in order to
remove the residue.
Keep a small amount of cream on
the residue as you scrape.
After scraping with the razor
scraper, use the scrub sponge to
remove any remaining residue.
Shake the cleaning cream well. Apply
a few drops of the cream directly to
the cooktop.
Use a paper towel or sponge to clean
the entire cooktop surface.
NOTE: It is very important that you DO NOT heat
the cooktop until it has been cleaned thoroughly.
If any residue remains, repeat the steps
listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with Cerama Bryte®
and a paper towel.
For additional protection, after all
residue has been removed, polish the
entire surface with Cerama Bryte® and
a paper towel.
NOTE: Razor blade is packed inverted for safety
reasons. Prior to use, the blade must be rotated
and reinserted into slot. Do not use a dull or
nicked blade.