Trim Sending Unit Adjustment - BRP EVINRUDE E-TEC 200 Service Manual

Trim Sending Unit Adjustment

Tilt the outboard and engage the tilt support.
Temporarily install a thrust rod, P/N 436541, in the
number 3 hole.
Loosen the send ing unit screws, to allow the
sending unit to pivot.
1
1. Screws
Disengage the t ilt suppo rt. Lower th e outbo ard
against the thrust rod.
Observe the trim gau ge. If the n eedle does not
show cen ter position, tilt the
adjust the sending unit by pivoting it up or down.
1
1. Needle at center position
Lower the outboard against the thrust rod to check
29072
adjustment. Repeat adjustment, if necessary.
After a djustment is correct, tilt
tighten the two sending unit screws, and remove
the thrust rod.
Trim Limiter Rod
The trim limiter rod prevents excessive trim down.
As the engine is trimmed to the full down position,
the bow of the boat goes deeper into the water.
•
If th e trim limiter rod is lef t out, the bo w could
plow into the wat er cau sing the boa t to "bow
steer" resulting in a loss of control.
•
If the trim limiter rod is set too far o ut, the p ro-
peller could ventilate, resulting in poor accelera-
tion when the boat is coming onto plane.
27339
Set th e trim limiter rod to pre vent excessive trim
down and provide good acceleration. The trim lim-
iter rod can be u sed to prevent th e gearcase or
spray deflector from contacting the transom.
When the outboard is returned to the cus-
tomer, the trim limi
installed and in the s ame l ocation as it
was when the motor was brought in
service. Leaving the trim limiter rod out, or
changing the adjustm ent, cou ld allow the
motor to une xpectedly trim in too far and
cause loss of control.
.ROUTINE SERVICE
ADJUSTMENTS
outboard up an d
the outboard u p,
A
WARNING
ter rod must be
2
000662
for
29