LIFTING THE
OUTBOARD
A
WARNING
To avoid personal injury, make sure the lift-
ing cap acity of the hoist is at least twice
the weight of the outboard.
DO NOT all ow the lif t hook or chain from
the hoist to come in contact with any part
of the engine during lifting.
Use correct Lifting Fixture to lift outboard:
Model
90° V6
Place lif ting tool on flywh eel and se at the three
screws completely.
1
1. Lifting fixture
2. 1 3/4 in. screws
Fasten appropriate chain hoo k to eye of too l.
Carefully hoist outboard with chain and unbolt out-
board mounting brackets from frame.
OUTBOARD RIGGING
CONNECTIONS
IMPORTANT:
and remote control installation information, refer to
the Predelivery and In stallation Guide included
with the service manual set.
Common Practices – All Models
Control Cable Identification
IMPORTANT:
before rigging outboard.
Identify each control cable:
Lifting Fixture
•
P/N 396748 with
1 3/4 in. screws
2
1. Shift cable casing guide extended to midpoint
2. Throttle cable casing guide retracted
Extend the control cables and lubricate them with
002419
Triple-Guard grease.
LIFTING THE OUTBOARD
For complete
Identify con trol ca ble fun ction
Put the co ntrol handle into NEUTRAL positio n.
The throttle cable casing guide will retract com-
pletely and the shift cable casing guide will go to
the midpoint of its travel.
.ROUTINE SERVICE
outboard riggin g
1
2
DP0811
30501
17
2