Break-In Oiling - BRP EVINRUDE E-TEC 200 Service Manual

Running a n Evinrude E-TEC out-
NOTICE
board on other grades of oil while s et to the
XD100 oil ratio will res ult in increased engine
wear and shortened outboard life.
Powerhead oil prog ramming la bels are provided
to ident ify EMM oil prog ramming. Inst all the cor-
rect label to alert user to specific oil requirements.
1
1. Evinrude/Johnson XD30 outboard lubricant (TC-W3)
YELLOW label
2. Evinrude/Johnson XD100 outboard lubricant (Premium)
BLUE label (Installed)
An XD100 Outb oard Oil De cal, P/N 352369, is
available to la bel b oats equ ipped with o utboards
that have been progra mmed for the redu ced oil
injection ratio.
NOTICE
This outboard has been programmed for
®
the use of Evinrude
outboard oil ONLY.
Failure to use Evinrude
XD100™ outboard oil may harm engine
performance and shorten engine life.
XD100 Outboard Oil Decal
2
004964
®
/Johnson XD100™
® ®
/Johnson
355627
355627
OIL CONTROL SETTINGS
Install decals in a hig hly visible locatio n, such as
one of the following:
•
Dashboard/deck of boat, next to key switch
•
Deck of boat, next to the remote oil fill
•
Deck of boat, next to oil tank assembly
•
Oil tank cover
•
Cover of oil tank compartment
•
Attach to oil tank or oil fill cap.
IMPORTANT:
Make sure the engine label an d
boat decals match EMM programming.

Break-In Oiling

IMPORTANT:
DO NOT add oil in the fuel tank
on Evinrude E-TEC models.
The EMM automatically supp lies extra oil to the
engine as follows:
•
90° V6: First two hours above 2000 RPM
Follow these steps for outboard set-up:
Use Evinrude Diagnostics software to ma ke sure
the break-in pro gram has been started on a new
outboard.
•
Use th e diag nostics software to st art bre ak-in
oiling after a powerhead rebuild.
1
1. Break-in oil setting
The operator m ust mo nitor the oil
NOTICE
tank level to co nfirm oil cons umption. Th is
may require several hours of operation above
idle.
OILING SYSTEM
8
008571
169