OILING SYSTEM
OIL SYSTEM REQUIREMENTS
OIL SYSTEM
REQUIREMENTS
Recommended Lubricants
Evinrude/Johnson XD100, XD50, or XD30
board oils are recommende d for use in Evinrude
E-TEC outbo ards. If these oils are no t available,
you must use a TC-W3 certified oil.
Evinrude/Johnson XD100 o utboard oil is h ighly
recommended for all conditions and applications.
Engine Lubricant Below 32°F (0°C)
If the outboard will be operat ed in temperature s
below freezing (32°F, 0°C), use Evinrude/Johnson
XD100.
IMPORTANT:
For new o utboards, test low oil
warning before filling oil tank.
Turn key switch to ON. The engine mon itor warn-
ing display should show "LOW OIL."
Add enough oil to raise level to at least one-quar-
ter capacity.
The "LOW OIL" warning should not display.
Failure to follow these recom men-
NOTICE
dations could void the outboard warranty if a
lubrication-related failure occurs.
164
COMPONENTS
The oiling system consists of the following compo-
nents:
•
Oil tank
•
Oil injection pump and manifold assembly
out-
•
Oil pressure sensor
•
Electrical circuit
•
LOW OIL and NO OIL warning systems
•
Cylinder and crankcase
•
Rear oil manifold assembly (3.3 L models)
•
Rear oil pump (3.4 L models)
•
Oil recirculation system
Oil Tank Assembly
The oil tank must be properly positioned and t he
oil level must be monitored. Refer to the Predeliv-
ery and Installation Guide.
Oil Tank Components:
•
Tank, 1.8 or 3.0 gallon capacity
•
Oil pickup and filter assembly
•
LOW OIL sending unit
•
Mounting bracket and hardware
•
Protective cover (1.8 gallon tank only)
•
Primer bulb and supply hose.
1.8 Gallon Oil Tank Kit
44839B