Page 1
Perform one of the following actions: For a new RS485 connection installation, disconnect the 6-pin connector from the surge protection board, and connect the two sets of RS485 wires to the G, A, and B terminals, as shown in the figure below. Channel 1 Figure 2: Connecting RS485 Wiring RS485 Surge Protection Kit Installation Guide - MAN-01-00597-1.0...
Page 2
If RS485 connection is already installed in the inverter, disconnect the 6-pin connector from the inverter’s communication board (leaving the RS485 wires intact). Figure 3: Communication Board and 6-Pin Connector Screw the standoff spacer into its socket as shown in the below figure. Place the surge protection device over the spacer so that the screw opening is aligned with the spacer, and insert the screw into the spacer via the indicated screw opening in the device.
Page 3
Connect the 6-pin connector to the surge protection device. 10. Close the inverter cover. 11. Turn ON the AC to the inverter. 12. Turn the Safety Switch (if applicable) to ON. 13. Turn the inverter ON/OFF/P switch to ON. RS485 Surge Protection Kit Installation Guide - MAN-01-00597-1.0...