Table of Contents
Advertisement
4.6 Hyper Terminal Set-Up on the IBM Compatible PC
Boot up the computer and start the serial data capture software such as the Hyper Terminal
program. Hyper Terminal may be located in the Programs section or in the Accessories section
under Communications, and Hyper Terminal will be used for the balance of the examples used in
this manual.
Under the New Connection window:
Under the Connect to window:
Under the Com ? Properties window:
Select the Port Settings tab and set the following:
Select OK
In the Hyper Terminal window select File then click on Properties.
Under the Com ? Properties window click on the Settings tab.
Note: Past versions (Ver. 5 thru 6) of HyperTerminal have a known issue when communicating with serial
protocols of 7 data bits, 1 stop bit, odd parity. This Windows® program will not correctly auto detect the protocol,
but will display the data when manually configured.
Choose an icon then select an identifying title such as "Test."
Select OK after you have made your choices.
-Choose Connect Using Com 1 or whatever Com port you have chosen to use.
After your selection click on OK.
Bits per second:
Data bits:
Parity:
Stop Bits:
Flow Control:
Set the following:
Function, arrow, ctrl keys to act as Terminal Keys.
Emulation to Auto Detect
Under ASCII Setup
The software is now configured for operation.
9600
8
None
1
None
Set the following:
Echo off.
Wrap lines that exceed terminal width.
Select OK.
Page 20 of 57
Advertisement
Table of Contents
