Teledyne Lecroy HDO4000A Quick Start Manual

HDO4000A/HDO6000A Rackmount Accessory
7. Use the remaining four M4x10 Phillips screws to attach the top bracket to the left
and right walls.
8. Follow your rack manufacturer's instructions to install the rackmount into your
rack, using four fasteners through the four holes at the outside edges of the
faceplate. Be careful not to block the cooling vents at the sides of the oscilloscope.
CAUTION: This rackmount kit is designed to fit standard 19-inch rack cabinets
per EIA/ECA 310-E. It has been designed for heated air exhaust through vents
on the left and right sides of the instrument. Some rack cabinets might present unusual
obstacles that can block exhaust vents. If you observe such obstacles, please contact
Teledyne LeCroy technical staff for further guidance.
Contact Us
For a complete list of Teledyne LeCroy offices by country, including our sales and
distribution partners, visit: teledynelecroy.com/support/contact
© 2021 Teledyne LeCroy, Inc. All rights reserved.
HDO and Teledyne LeCroy are trademarks of Teledyne LeCroy, Inc. Other product or brand names are
trademarks or requested trademarks of their respective holders. Information in this publication supersedes all
earlier versions. Specifications are subject to change without notice.
Unless otherwise specified, all materials and processes are compliant with RoHS Directive 2011/65/EU in its
entirety, inclusive of any further amendments or modifications of said Directive. For the full list of current
certifications, see the EC Declaration of Conformity shipped with the product.
933201-00 Rev A
hdo-rackmount-instructions.pdf
February, 2021
4
HDO4000A/HDO6000A Rackmount Accessory
Thank you for purchasing a Teledyne LeCroy rackmount accessory. Please review these
instructions before installing the rackmount.
The rackmount kit is shipped with the following parts. Contact our Customer Service if
parts are missing.
Parts
Top bracket
Faceplate
Faceplate handle
Left wall
Right wall
Tray base
M4x10 Phillips screws
M5x12 Phillips screws
Note: The kit does not include the fasteners needed to attach the rackmount to your
rack. Consult your rack manufacturer regarding the appropriate type, size and number
of fasteners required to install the rackmount securely.
Tools
You will need a Phillips (#2 head) screwdriver to assemble the rackmount.
Assembly
1. Power down and unplug the AC line cord from the back of the instrument.
2. With the feet rotated forward (as shown below), fold down the flippers so the
instrument sits flat. You do not need to remove the feet.
933201-00 Rev A
QTY
1
1
2
1
1
1
15
4
1